Страница 1 из 1

am29f800bt

Добавлено: Пт окт 24, 2014 2:39 pm
popaj2004
Hi there

I have a willem pcb50 programmer.Am29f800bt chip from VW Passat ecu.Soldared in adapter ID was ok.

Then i read the chip-----ok.
Write chip----------------ok.
Verify---------------------ok.
Then ERASE CHIP--------OK.

After erase no more valid ID.I still can read the chip getting all FFFFF.Blank check-----its empty.

Then i soldered 1 new am29f400 and ID is ok.Can write read,verify.


So: 1.Can it be to erase ID?How to get it back?
2.Do i have to erase a chip before write tunned file or will it be overvritten?

Re: am29f800bt

Добавлено: Сб окт 25, 2014 3:58 pm
Ezo
1.Can it be to erase ID?How to get it back?
ID cannot be erased. Recheck chip pin contacts.
2.Do i have to erase a chip before write tunned file or will it be overvritten?
Erase chip before write new one.

Re: am29f800bt

Добавлено: Вс окт 26, 2014 6:56 pm
popaj2004
Soldered again and no ID.

Ok now i will try to erase the 29f400 and we will see if the ID stays.

Re: am29f800bt

Добавлено: Вт окт 28, 2014 1:26 pm
popaj2004
Ok

Seems like the am29f800 is fault.With Am29f400 everything ok---can erase and write with no problems.


Another thing:When i write back the tunned file there is a option at the right says Skipp write 0xFF.This must be enabled or not?

Re: am29f800bt

Добавлено: Вт окт 28, 2014 9:22 pm
Ezo
Another thing:When i write back the tunned file there is a option at the right says Skipp write 0xFF.This must be enabled or not?
Result should be the same
Enabled - byte write skipped, directly to verify (erased chip has all 0xFF)
Not enabled - fullfill byte 0xFF write, then verify.
You can win a bit programming time if source file partly with content data