EZoFlash форум

hi ezo
does willem or pcb3bx modified do the chip 28f640 tsop56 if yes how about adapter where i can find it thanks.
enie.

No direct adapters available. Apply crossadapter ezowill+tsop56a1

hello ezo
thanks for reply and how about this adapter

It is generic top tsop56 socket. I do not find base for willem.

thanks ezo but for your tsop adapter there is a problem to put the meritec tsop adapter on the 56a1 board because the lines are too thin how can i do to adjust the meritec adapter in ordrer
to solde it like in the picture thanks for reply.
enie.

I recomend use adapter with chip soldering by default.
Apply soldering iron with fine tips and hot air soldering iron. Keep right temperatures.
Same equipment is required to remove chip from device and solder back.
Meritec socket is recomended for regular use. Socket soldering on adapter not easy - soldering experience , iron with thin tips, microscope and good light required.

Once you have the info from the TSOP read - What is my next step ?

Which software do i use ? - I know for AVR3 you use eepedit.

Could someone please help me out. or direct me to a faq that can help me.

I am on minimum sub.

Thanks
Goodbye.