Ezoflash parts list
Добавлено: Вт дек 10, 2013 6:02 am
Hi, I have a few questions about the parts used in ezoflash.
*Resistor
-Can I use 0.125watt or 0.1watt resistor? Is 0.1watt resistor enough?
*Capacitor
-Are these 470nF and 220nF ceramic, mylar or tantalum??
-What is the minimum voltage rating I should use?
*Diode
-Can I replace BAT41 with 1n4148? Will it cause problems or affect performance?
-Can I replace 1n4148 and BAT41 with BAS16J or MMBD4148?
http://www.nxp.com/documents/data_sheet/BAS16_SER.pdf
http://www.nxp.com/documents/data_sheet/MMBD4148.pdf
*Transistor
-Can I replace BC327 with BC807-16LT3G?
http://www.digikey.com/product-detail/e ... ND/1475921
*Resistor pack
-Why does parts list say it is 10kx9 but the schematic say it is 10kx8?
http://www.ezoflash.com/ezoflash4v5/ezo_partlist.htm
http://www.ezoflash.com/ezoflash4v5/ezo_schematics.htm
*Resistor
-Can I use 0.125watt or 0.1watt resistor? Is 0.1watt resistor enough?
*Capacitor
-Are these 470nF and 220nF ceramic, mylar or tantalum??
-What is the minimum voltage rating I should use?
*Diode
-Can I replace BAT41 with 1n4148? Will it cause problems or affect performance?
-Can I replace 1n4148 and BAT41 with BAS16J or MMBD4148?
http://www.nxp.com/documents/data_sheet/BAS16_SER.pdf
http://www.nxp.com/documents/data_sheet/MMBD4148.pdf
*Transistor
-Can I replace BC327 with BC807-16LT3G?
http://www.digikey.com/product-detail/e ... ND/1475921
*Resistor pack
-Why does parts list say it is 10kx9 but the schematic say it is 10kx8?
http://www.ezoflash.com/ezoflash4v5/ezo_partlist.htm
http://www.ezoflash.com/ezoflash4v5/ezo_schematics.htm