Ezoser red led stays on always
Добавлено: Ср мар 14, 2012 2:01 am
Connect LPT cable to PC and programmer.
Run Willem software.
Connect power supply to programmer.red led stays on (no flash just steady)
Run Willem SW command Help/Test Hardware(hardware error check connection)setup97ja
When run Sw test hardware Green led flash very fast once and gives me error massage
I checked all circuit thinking about a cut trace or maybe missing trace.everything is ok I checked the cable from lpt too and Lpt is standart on my bios win xp .
Is there any guide for ezoser ? or maybe a tip or something that guides me .
I'm building ezoflash 4.3 version but now need to program spi 25128-25256 eeproms ,wanna make work ezoser 1st and then continue with the other programer.
I wait for your answer Mr Ezo.