Страница 1 из 1

OE problems ezo 4v4

Добавлено: Сб май 25, 2013 12:15 am
quinhomvs
My ezoflash 4v4 this with problems in OE.

OE-24 active in test/HW = 0.90 volts

0E-24 desactive in test/HW = 0

d0..d7 > 0,50 volts with OE desactive in test/HW

Re: OE problems ezo 4v4

Добавлено: Сб май 25, 2013 11:38 am
Ezo
Check OE voltage changes on programmer elements IC7/10,IC7/11, IC5/13, IC5/14

Re: OE problems ezo 4v4

Добавлено: Пн май 27, 2013 3:52 pm
quinhomvs
mode ECP+EPP
With programmer not connected in the LPT1

IC7/10 - 0,01 Volts
IC7/11 - 4,96 Volts
IC5/13 - 4,96 Volts
IC5/14 - 4,96 Volts

With programmer connected in the LPT1

IC7/10 - 0,01 Volts
IC7/11 - 4,96 Volts
IC5/13 - 4,96 Volts
IC5/14 - 3,38 Volts

-------------------------------------------------
changed parallel port for mode NORMAL - below

With programmer not connected in the LPT1

IC7/10 - 0,01 Volts
IC7/11 - 4,96 Volts
IC5/13 - 4,96 Volts
IC5/14 - 4,96 Volts

With programmer connected in the LPT1

IC7/10 - 0,01 Volts
IC7/11 - 4,96 Volts
IC5/13 - 4,96 Volts
IC5/14 - 4,85 Volts
------------------------------------------------

Re: OE problems ezo 4v4

Добавлено: Пн май 27, 2013 10:25 pm
Ezo
Check voltage changes. Test H/W . Mark/unmark OE-24 box

Re: OE problems ezo 4v4

Добавлено: Пн май 27, 2013 11:07 pm
quinhomvs
OE-24 unmark

IC7/10 - 0,01 Volts
IC7/11 - 4,96 Volts
IC5/13 - 4,96Volts
IC5/14 - 4,86 Volts

OE-24 Mark

IC7/10 - 0,90 Volts
IC7/11 - 0,01Volts
IC5/13 - 0,01 Volts
IC5/14 - 0,14 Volts

Re: OE problems ezo 4v4

Добавлено: Пн май 27, 2013 11:14 pm
Ezo
Fail logic element output IC7- 10
Usually short between lines. Inspect carefully lines from IC7/10 to IC4/15, from IC7/10 to BUS BU3/12.

Re: OE problems ezo 4v4

Добавлено: Пн май 27, 2013 11:54 pm
quinhomvs
inspected the points described, there is no short, is that one of them is burned (IC7 and / or IC4)?

sorry for the english, translated