No power or connection detected from PCB V 5.0

By: Molegrip - 2008-11-09 07:02:04

I have recently bought a PBC V 5.0 from Sivava and have powered the programmer as per the supplied schematic. But the unit is not detected with usb connection during h/w test. Could any one clarify for me the connection setup. Thanks

Re: No power or connection detected from PCB V 5.0

By: DL - 2008-11-09 15:32:19

Hi,

I/O requires a parallel cable.  USB is only for power.

HTH,
Dennis

Re: No power or connection detected from PCB V 5.0

By: Molegrip - 2008-11-09 20:22:07

DL thanks for your reply you have probably gathered that I am a Willems programming guru (ha-ha).....
It's good news but a blow really was hoping to power from the laptop but looks like I will have to drag the pc out & use the device with that.
Thanks again for the heads up much appreciated...

Mole...