Hi
I want to disable PM29F002T top boot block lockout. but this does not work.
- enter - "u". but loop.
I used willem 3b clone. need high voltage to A9?
Also, about Utility PM29F002T.exe
Can I use in EZoFlash+4v4 this software? or Can I use in EZoFlash4v5 this software? or willem programmer?(version??)
Thanks
Utility PM29F002T.exe
- Вложения
-
- boot_block_loop
- pm29f002t_top_boot_block.JPG (92.95КБ)29744 просмотра
Re: Utility PM29F002T.exe
No. Here is simply SW command.I used willem 3b clone. need high voltage to A9?
It should work on any pcb3b compatible hardware, Vcc =5VCan I use in EZoFlash+4v4 this software? or Can I use in EZoFlash4v5 this software? or willem programmer?(version??)
EZoFlash4v5 use with jumpers Jp97.
Generally looks ok, correct ID and status returned.Also, about Utility PM29F002T.exe
Place utility in same 0.97ja directory .
Is the utility downloaded from link in Home section ?
I have to recheck issue, utility is very old project.
Try search experience in forum PM29F002T, unfortunately most in russian.
Try read/write/erase with old SW 0.97g, 0.94 (ID not supported, blank check may fail - use read/buffer check after erase, otherwise ok). Select 29F002 .
Re: Utility PM29F002T.exe
YES.Is the utility downloaded from link in Home section ?
I tried SW 0.97g, 0.94. after erase, read buffer result is not all 0xff, and it could not even write 1 byte from 0x00000 by verify error.