please can you give me the pictures of ezoflash with a kd522 diodes and to tell me a direction of diodes to put in beacose in each ic is 5.0v. or ezoflash always 5 V on Data Lines
thanks
regards
hi olways on ic data 5.0v
Re: hi olways on ic data 5.0v
My sample and all pictures are with russian diod KD522. Diod is equal to 1N4148, different marking. Place your equal diod according diod polarity shown in comp picture.
Run ezoflash_testhw (see guides) in Test H/W mode.
Diods are correct if you are getting different voltages at Vcc with different Jp1..3 settings.
Usually data lines are on high impedancy by default.
Run ezoflash_testhw (see guides) in Test H/W mode.
Diods are correct if you are getting different voltages at Vcc with different Jp1..3 settings.
Is it in Test H/W mode ?ezoflash always 5 V on Data Lines
Usually data lines are on high impedancy by default.
Re: hi olways on ic data 5.0v
thnkyou very much but in my west hw mode are oll disable and in ezoflash i put in
12v
12v
Re: hi olways on ic data 5.0v
Come back with test results http://www.ezoflash.com/testguide.htm
Re: hi olways on ic data 5.0v
hi thankyou very very much i sloved the problem now. thankyou very much for your helping