hi olways on ic data 5.0v

[laserkill]

please can you give me the pictures of ezoflash with a kd522 diodes and to tell me a direction of diodes to put in beacose in each ic is 5.0v. or ezoflash always 5 V on Data Lines
thanks
regards

[Ezo]

My sample and all pictures are with russian diod KD522. Diod is equal to 1N4148, different marking. Place your equal diod according diod polarity shown in comp picture.
Run ezoflash_testhw (see guides) in Test H/W mode.
Diods are correct if you are getting different voltages at Vcc with different Jp1..3 settings.

ezoflash always 5 V on Data Lines

Is it in Test H/W mode ?
Usually data lines are on high impedancy by default.

[laserkill]

thnkyou very much but in my west hw mode are oll disable and in ezoflash i put in
12v

[Ezo]

Come back with test results http://www.ezoflash.com/testguide.htm

[laserkill]

hi thankyou very very much i sloved the problem now. thankyou very much for your helping