hope this is the right place...
i just want to report a chip that is not in the chip_test file.
works perfect; read, write, erase, id -- all good.
___________________________________________
Atmel
AT49BV160DT
OK
16M
16
2,7-3,6
TSOP 48
used adapter: TSOP_48_D3
jumpers ezoflash 4.4: 2, 5, A, E
selected device: 28F160C3T
software: 0.97ja
vcc flash: +3,5
vpp: +3,5
reset prog/read: -
get id manuf.: 0x001F ATMEL
get id device: 0x90C2
comments: CFI OK
___________________________________________
i know the selected device is strange, it´s because the command definition.
the commands for AT49BV160DT is the same as for INTEL 28F160C3T.
so the AT49BV160D is also under the wrong collum in the documantation for the adaptor.
hope this helps.
excuse my bad english
