adapter tsop56A1

tps_star · Сообщение **tps_star** » Ср окт 08, 2008 12:33 pm

pin35 and pin36(BU7) for this adapter not need connect ?
or need jumper for connect and disconnect?

Сообщение **Ezo** » Чт окт 09, 2008 7:31 am

Yes, cut lines to pins 35 and 36. Jumpers Jp9 and Jp10 allow manually set 16Mb part of 32/64/128Mb chip to be read/programmed.

tps_star · Сообщение **tps_star** » Пн окт 13, 2008 5:52 pm

please give jumper setting this adapter for read and program device JS28F640J3D and software setting

Сообщение **Ezo** » Пн окт 13, 2008 6:22 pm

Read adapter doc's or from download

tps_star · Сообщение **tps_star** » Вт окт 14, 2008 6:33 pm

i make this adapter but can not working
i set jumper j1 j3 j5 and j7 for adapter and choice device LH28f160-T&B
but can not work
my device is JS28F640J3D
please help me ezo

Сообщение **Ezo** » Вт окт 14, 2008 9:02 pm

Why do not read doc's ?
>>>> - Vcc=2.7-3.6V. Vpen=3.3V . Jumpers Jp2 (+3.6V), Jp5 (A18), Jp7 (Vpp=3.6V) <<<<<
Set Jp2,Jp5, Jp7 and not J1,J3,J5 (here +5V Vcc)
>>>> 0-16Mb Jp10 on (A21-low), Jp9 on (A22-low) ; here check valid get ID response.<<<<<
Set Jp10, Jp9 and check get ID

tps_star · Сообщение **tps_star** » Вт окт 14, 2008 9:31 pm

sorry
i error type jumper
i set jumper JP2 JP5 AND JP7

Сообщение **Ezo** » Ср окт 15, 2008 8:40 pm

Are you getting valid get ID response ?

tps_star · Сообщение **tps_star** » Пт окт 17, 2008 8:58 am

no
i check with LH28f160-T&B
but no valid id

Сообщение **Ezo** » Пт окт 17, 2008 6:50 pm

I suppose programmer is working and verified.
Check target chip soldering on adapter, check adapter lines.
Use magnifier in good light.
Important to get valid ID reply 0x89 Intel 0x17 -